Boeing B-52 Stratofortress
Copyright Claim
Boeing B-52 Stratofortress
Boost
57
104
16
Print Profile(2)
"All at Once" 0.2mm layer, 2 walls, 10% infill
Designer
11.1 h
2 plates
Individual Parts
Designer
12.5 h
6 plates
Boost
57
104
16
0
240
98
Released
Description
A segmented and print ready Boing B-52 Stratofortress.
Model, once assembled, is 560mm (22") wide (wingspan) and 484mm (19") long (nose to tail).
Supports are required, and both wings should be printed in a vertical orientation to save on material and improve surface appearance.
The included print profile is for an “all in one” print (two plates). I personally recommend printing one piece at a time just in case there is any issue.
Comment & Rating (16)
All
Print Profile
"All at Once" 0.2mm layer, 2 walls, 10% infill
Goddamned LH wing wouldn't stay together using either gorilla glue or a hot glue stick.
(Edited)The designer has replied
0
Reply
What gorilla glue did you use? I used the gel version for the main print with good results, but you could try the baking soda trick too.
Thanks for the feedback though.
(Edited)1
Reply
Replying to @Catsmgee
Super Glue Gel XL......what kills me is the RH wing didn't have any issues. I wasn't aware of the baking soda trick. I'll give that a try. Thanks! I'll give you a star back since I think it was more of a function of the glue curing. If the baking soda trick works I'll upgrade to 5.
(Edited)0
Reply
Replying to @adooley1684
Weird, that's exactly what I used. I did scrape up the surfaces a bit but not much.
I'll take a closer look at the model tomorrow and see if there's anything I missed.
0
Reply
do I have to glue these together or what
The designer has replied
0
Reply
Yes, you glue the two body halves together, then the tail and the nose sections. I glued the wings on last.
I'm not experienced enough to design something snap-fit.
0
Reply
k thx
0
Reply
also what glue would you recommended
0
Reply
been waiting for one of these because my grandpa fought in the nam war in a b 52 so wanted to print one thank you
(Edited)1
Reply
do you happen to know what the scale is on this model? i found several decal kits but they are based on what scale the model is
0
Reply
Print Profile
"All at Once" 0.2mm layer, 2 walls, 10% infill
awesome print keep up the good work
0
Reply
Print Profile
"All at Once" 0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
"All at Once" 0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
"All at Once" 0.2mm layer, 2 walls, 10% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld