BULBINATOR - The 100% 3D Printed Bulb Planter

Perfect for any keen gardener!

Features:

• 80mm Diameter
• Serrated Cutting Edge
• Adjustable Handle To Suit Different Hand Sizes
• Attractive Design That Is Easy To Customize
• 120mm Planting Depth
• Metric And Imperial Depth Markers
• Rotating Handle (Print-In-Place)
• Easy Assembly

Assembly:

• Remove all brim material from the handle. Including the tiny strip that covers the V slot. A craft knife makes this quite easy.
• Slide both sides of the handle into the corresponding slots in the main body.
• Add a small amount of super glue to each slot.
• Slide the handle down to your desired position.
• Allow the glue time to set, or use some activator.
• Start planting!

Tips: You can try to print the handle without a brim to avoid the post processing, but there is a very thin line that has to remain stuck on the 1st layer. I have had a couple of failures when not using a brim but also a couple of successes - If not using a brim, you can monitor the first 6 layers. If there are no signs of warping then continue the print. If there are any signs of warping, then stop it and try again.

If you make it past layer 6 when printing the handle, then there should be nothing else to worry about.

The main body prints great with no brim.

Thanks for looking!

Please rate and review your printing experience :)