A Travel 9x9 Go board complete with pieces! Conveniently folds up to hold everything tidy while on the go!
The second of the two 9x9 travel go games. This one uses a styling I'm calling “scifi styling” Not sure how scifi it turned out, haha, but it's still pretty neat. I nearly completed the first one when I got the idea for this. I couldn't leave well enough alone though so had to give it a go, and thus, this was born!
Print the sides, mid section, and the cases. Print a set of the player pieces in each color. There should be 40 player pieces total. On the X1/P1, I recommend printing without the Aux fan to help avoid warping. Make sure your bed is clean too!
You'll need 4 M3x20 (there abouts, doesn't have to be exact) screws for the hinge, and 4 4x6mm magnets (Here's a link to an Amazon US listing). Be careful not to over-tighten the screws! You don't want a stiff hinge.