Katana V1 print in place, foldable sword
Remixed by
Copyright Claim
Katana V1 print in place, foldable sword
Remixed by
Boost
92
141
37
Print Profile(1)
0.2mm layer, 2 walls, 15% infill
Designer
8.3 h
1 plate
Boost
92
141
37
1
427
140
Released
Description
Nice Katana model i remixed from Three Wu See him out on makeitreal from ankermake !!
Easy print in place model
Enjoy !!
Comment & Rating (37)
All
Great design and easy print! My friend loves it!
The designer has replied
1
Reply
ty appreciated !!!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Excellent design and absolutely clean print! sword extended just from pulling it off the bed. nicely done.
The designer has replied
1
Reply
Amazing work !!! thanks for the review and pic !!! appreciated and enjoy !
0
Reply
This one was nice! Mine broke a bit but that is because I printed it too fast for my printer :') I was able to put it together and I had a lot of fun using it!
The designer has replied
1
Reply
Thanks for the review and comments !!!! appreciated
0
Reply
thanks my frenz for that cool file to print. ;)
The designer has replied
1
Reply
My pleasure mate :D
1
Reply
Any chance we could get the Katana pieces independently? The print came out beautifully, but I ninja'd too hard and the tip piece came flying out and shattered..
I had no idea I set it to projectile mode..but all I need it the smallest piece!
Thanks, killer file work!
The designer has replied
1
Reply
ill see what i can do for yallz !!! :D
1
Reply
can you make a model to where the handle opens and you could put it in piece by piece
The designer has replied
1
Reply
surely can, to have the blade another color !!! let me fix this for ya
0
Reply
so
cool
The designer has replied
1
Reply
tx for the review and rating !!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
Very good!
The designer has replied
1
Reply
thakns for the review and rating !! appreciated
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
works well and it was easy to print with no problems
The designer has replied
1
Reply
thanks for the review and rating aprpeciated !!
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
design was good but I used pla and it broke pretty quickly. maybe try something a bit tougher.
The designer has replied
1
Reply
Thanks for the review, im using pla and is pretty strong !! hmmm good luck and thanks for the rating !
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-NoDerivatives
© 2024 MakerWorld