Yet another phone stand/tablet stand inspired by many similar types already available.

I made this one with wider gap to put the phone/tablet in because so many people I've made these for have phone/pad covers that are really thick and they didn't want to keep taking the tablet covers off or excavate their wallet phones from the wallet part.

It's also at a steeper angle because some people I made other existing models here for complained when they facetimed with people, their double chin became very prominent :P This one works better at more of a distance and the camera at a more direct angle, so people you're facetiming or on zoom with or Teams aren't just staring up at your chin.

The gap on these is 22mm as opposed to the more common 15mm, which should leave enough room for any kind of phone/tablet cover and still work fine with phones/tablets that have no cover.

Remember to rotate the model sideways and use the "Lay flat" option in Cura or whatever other slicer you might use (as shown in the pictures), and limit supports to "touching buildplate" to save on filament for the hole in the back.

Or don't I guess if you don't care. Supports "Everywhere" does make them less likely to snap higher up in the print, but can be annoying to remove with PETG.