Soft Tape Measure Spool (Remix)
Remixed by
Copyright Claim
Soft Tape Measure Spool (Remix)
Remixed by
Boost
8
10
8
Print Profile(1)
0.28mm layer, 2 walls, 15% infill
Designer
42 min
1 plate
Boost
8
10
8
0
63
46
Released
Description
This is a remix, where the post is a snap-in model where no gluing is needed.
Tolerances are tight, you may want to use a small dab of silicon grease to help make turning smoother.
Supports are recommended.
Comment & Rating (8)
All
Print Profile
0.28mm layer, 2 walls, 15% infill
Prints without and issue and fits together securely. Needs some force to fit the 2 pieces together and leaves the mechanism quite tight (squeaks when winding, even after a decent amount of wearing in), but overall, does exactly as required with no additional tweaking needed.
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
Broke when connecting the two parts.
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
It would be nice if it spun more freely.
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
Strength Issue:failed when trying to connect the parts
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 2 walls, 15% infill
0
Reply
No more
This remix is based on
The model does not exist anymoreLicense
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRemixes (1)
© 2024 MakerWorld