Just a simple but expandable photo booth.

I used The model Mad hatter from Reddadsteve's creation to illustrate my point. Nobody wants to see my basement walls and nobody wants to see partial backgrounds. I wanted a expandable photo booth. All components have slots to build upwards or outwards.

I was testing this so I mixed and matched filaments on hand, not advised for cleaner look. This could be a large print if all sections are printed. Keep enough filament on hand before starting.

I used the cool plate with glue to make sure it didn't pop up during printing. The connectors are tight. I gave a good firm hammer using my palm of my hand on the three connection points.

Turn off flow calibration on printer before print starts. Even with that turned off you will have a little test line to peel off. This print is tight on the print bed if you move it in slicer you may have to reload it.