Desk Cable Chain
Desk Cable Chain
Boost
91
223
25
Print Profile(2)
0.2mm layer, 2 walls, 8% infill, no supports
Designer
29 min
1 plate
EndModules, 0.2mm layer, 2 walls, no supports
Designer
41 min
1 plate
Boost
91
223
25
1
246
207
Released
Description
A great way to organize your cables leading up to your desk.
Print how many you need, each module adds 60mm of length to the chain. No supports needed. Simply push the cables in the channel and slide in the snap-fit clip to hold them in place.
The end-connector modules to attach the chain to a flat surface (e.g. your desk) are provided in the “EndModule” print profile.
Comment & Rating (25)
All
Print Profile
0.2mm layer, 2 walls, 8% infill, no supports
looks and works great. With all of my 2 cables the chain is probably overkill but I'm very happy
The designer has replied
0
Reply
Looks great :)
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill, no supports
well needed 3d
0
Reply
can u make it a but more closed up?
The designer has replied
0
Reply
Do you mean a version that contains a front and backplate instead of the 2+1 connectors between the two sides?
0
Reply
I mean to the top and bottom is more closed so u see the cable in there a bit less
0
Reply
Replying to @Henry_TLE
Understood. I’ll think about that, how it would be possible while keeping the prints without support material and making sure the cables won’t push those covers off.
1
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill, no supports
Very nice. Fits perfect. Maybe you can upload a beginning and end piece
The designer has replied
0
Reply
Thank you for your feedback! Yes I will do that hopefully within the next 2-3 days.
0
Reply
Replying to @rauberdaniel
Cool. That´s great. Thanks
0
Reply
Replying to @user_1232828401
I added a simple version of end-pieces that allow connecting to flat surfaces. It’s available as a separate print profile.
(Edited)1
Reply
nice, but need to be printed with support.
The designer has replied
0
Reply
I’ve designed it to be able to be printed without supports, and all my tests worked fine.
0
Reply
absolutely perfect! thank you!!!
0
Reply
Print Profile
EndModules, 0.2mm layer, 2 walls, no supports
Not so flexible as I have thought
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill, no supports
The designer has replied
0
Reply
Hey, may I ask what issue you had with the model / print profile?
0
Reply
Print Profile
EndModules, 0.2mm layer, 2 walls, no supports
0
Reply
Print Profile
0.2mm layer, 2 walls, 8% infill, no supports
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld