Hat Pen Clip
Copyright Claim
Hat Pen Clip
Boost
32
51
8
Print Profile(2)
0.2mm layer, 6 walls, 25% infill
Designer
29 min
1 plate
PLA & PETG, all printers, 0.2mm layer, 6 walls, 25% infill
53 min
2 plates
Boost
32
51
8
1
60
56
Released
Description
I designed and tested a pen clip for hats. I am a server and typically wear a hat and usually just shoved it in the side of my hat. Since I started 3D printing this is the first real practical design I have made. Designed from measurements for a G pen, but should work with other pens as well.
Comment & Rating (8)
All
Print Profile
PLA & PETG, all printers, 0.2mm layer, 6 walls, 25% infill
didn't fit a standard bic pen or sharpie as posted. but after remixing the stl in fusion to scale the C shape while keeping the hat portion the same, they work perfectly.
The designer has replied
0
Reply
You were rating the print profile - for example; did it print correctly, stick whilst printing, quality print. You commented on the design for which (unfortunately) there is NO rating system. You may not be aware, I did not design the clip, I only made it available on all printers as the original uploader only made it available for the A1 printer. If you think it printed well, you may wish to rate based on that - I'm good either way.
0
Reply
This Is awesome.
1
Reply
0
Reply
Print Profile
PLA & PETG, all printers, 0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
(Edited)
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld