DeathStar Lamp kit adapter
Remixed by
Copyright Claim
DeathStar Lamp kit adapter
Remixed by
Boost
134
196
10
Print Profile(1)
0.2mm layer, 6 walls, 25% infill
Designer
46 min
1 plate
Boost
134
196
10
0
303
56
Released
Description
Support for the death star adapted to the kit - 001
https://makerworld.com/en/models/82213#profileId-87606
Puedes comprar el kit-001 en Bambu Lab o en Ali express
https://eu.store.bambulab.com/en-es/products/led-lamp-kit-001
Modification of the support to be able to hold the cable and avoid breakage. Adjustment of the support on the death star to avoid using glue or any other type of extras. Increased the lower hole so that the cable comes out without problems
Comment & Rating (10)
All
Print Profile
0.2mm layer, 6 walls, 25% infill
nice
0
Reply
I haven’t been able to find the actual Death Star lamp can someone provide a link or tell me where to find it.
1
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
very well done
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
It didn't fit the death star that I had printed. It would not fit into the base opening of it. Not sure why. It fit the LED lamp kit perfectly though so I don't think I could just scale the model down.
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
Just waiting on the LED puck to arrive but I’m sure it will fit.
(Edited)0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
Print Profile
0.2mm layer, 6 walls, 25% infill
0
Reply
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld