Storage Unit by Captain_May

Captain_May

Tools>Organizers

GIF

Print Profile(2)

All

P1P

P1S

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

10.7 h

1 plate

5.0(2)

0.2mm layer, 6 walls, 25% infill

Designer

6.5 h

1 plate

4.0(1)

Boost

192

Released

Description

Storage unit to hold many small items from crafts to workshop screws. Each drawer has a stop on its back side to keep it from falling out when opening. Just tilt up slightly to remove the drawer.

Each drawer has a 3mm x 2mm magnet to keep it from sliding out if at an angle. Back of unit also has matching magnet slots.

Designed for no supports.

Wall mount holes may not work due to drawers touching back plate for magnets to hold. I will try to redesign it for hanging.

Comment & Rating (13)

@user_153269408

Hi there Looks like a nice storage solution. - However, the provided drawers will not fit as intended. They only go in front side first and I'm sure that is not what you intended (see pic). Would you be so kind as to double-check your upload and provide a drawers.stl that fits in the right way? Thank you so much. Kind regards

The designer has replied

@Captain_May

the lip on the rear of the drawer is to prevent the drawer from accidentally fall out when pulling it out to far. Have you tilted the drawer slightly up to get lip in first? I will in meantime check the stl.... thank you for your response

@user_153269408

Replying to @Captain_May :

Whoa, indeed. That does it - thanks! Sorry to have bothered you, but I just tried to slide it in the most obvious way. Good idea actually to have the lip preventing accidental fall-offs..

(Edited)

@Captain_May

Replying to @user_153269408 :

no bother at all. I'm happy it's working for you and that you get many uses out of it.

@user_153269408

Ideal for all the small stuff like filament clips, adapters, short cables and other spare parts. Functional and looking good. I keep it on my desk, so the wall mount holes being flush with the back of the drawers don't bother me.. @CaptainMay Thanks for all the work you put in it! Thought I might share a pic or two.. - here you go: (ran out of magnets, so I made only ~ 1/2 of the drawers magnetic)