(No Supports) Tool/Thors Hammer Wall Mount (Multiple Versions) by Codyinbody3

Codyinbody3

Tools>Other Tools

Print Profile(2)

All

P1S

P1P

X1 Carbon

X1E

A1 mini

(PLA Profile) 0.2mm layer, 4 walls, 15% infill

Designer

7.1 h

4 plates

4.7(9)

A1 Mini - 0.2mm layer, 2 walls, 15% infill

7.4 h

4 plates

Boost

Released

Description

I recently designed a multicolor wall mount for my Chiefs and Thor's Hammer. The ones I saw on all the other sites were not long enough out from the wall or were too thin and had nothing to keep it from coming off the front in case of an accident. So I decided I'll make one myself and I think this one turned out pretty good. It fits the hammer I made perfectly and I also made different versions which you'll see in the 3mf. There's a small, medium, and large wall mount for power tools, hand tools, yard & garden tools. I designed it to take just about any drywall screw, now on the smaller one, it takes a smaller diameter screw but will still hold up perfectly. I plan on making more little useful prints like these in the future to go with all the other things I've made to diversify my model. Enjoy!

Comment & Rating (11)

@3DSportsBeard

Print Profile

(PLA Profile) 0.2mm layer, 4 walls, 15% infill

In hindsight, I should have increased the size of this by 10-15% or so, since my hammer is so large. It doesn't sit as intended but thankfully it still works and looks great!

The designer has replied

@Codyinbody3

Which one did you print out of the 4 plates? I scaled my hammer up to as big as possible on my plate and my wall mount fits mine perfectly. The one I used was on plate 4. It looks like you may have printed one of the smaller ones possible. Plate fours mount should stick out further than the hammer and the hammer head should be resting on the mount. Not the handle part where it gets bigger.

@3DSportsBeard

Replying to @Codyinbody3 :

I printed plate 4 but I tweaked my handle and the connector piece that goes into the hammer to allow a dowel rod to go through so that’s why that piece is resting on the stand instead of the hammer.

@FingRidiculous

Print Profile

(PLA Profile) 0.2mm layer, 4 walls, 15% infill

@frshbydesign

Print Profile

(PLA Profile) 0.2mm layer, 4 walls, 15% infill

@Primalghost

Print Profile

(PLA Profile) 0.2mm layer, 4 walls, 15% infill

Can not get to print right

@BewareDeathclaw

Print Profile

(PLA Profile) 0.2mm layer, 4 walls, 15% infill

@eekoner

Print Profile

(PLA Profile) 0.2mm layer, 4 walls, 15% infill

@jasonwesterfiel

Print Profile

(PLA Profile) 0.2mm layer, 4 walls, 15% infill

@JMiller2024

Print Profile

(PLA Profile) 0.2mm layer, 4 walls, 15% infill

(Edited)

@ct.fusco77

Print Profile

(PLA Profile) 0.2mm layer, 4 walls, 15% infill

No more

License

This work is licensed under a Standard Digital File License.

You shall not share, sub-license, sell, rent, host, transfer, or distribute in any way the digital or 3D printed versions of this object, nor any other derivative work of this object in its digital or physical format (including - but not limited to - remixes of this object, and hosting on other digital platforms). The objects may not be used without permission in any way whatsoever in which you charge money, or collect fees.