Helmet V2.x:

Multicolor version:

• Slide the head into the Helmet like described below
• Sand/clean the visor
• Push the visor in by first pushing it in at the top and then along the entire length
• It should hold without glue, but you can also glue it from the inside

Iron Man is wearing the multicolor version in this picture and holds the closed version.

Helmet:

• Check the inside to see if it has been printed cleanly and remove any filament debris that is sticking out
• Has the brim been removed cleanly?
• The elephant foot can cause the inner rim to be a little too narrow, just sand the inner rim down a little or work it with a knife
• Slide the head into the helmet and press it in with gentle force on the chin

Hands:

• If the repulsor does not fit into the hole in the hand, carefully widen the hole with a scalpel or similar
• Apply small droplets of glue and glue in the repulsor.
• The new shape makes the hand a little more rigid, but with a little careful force it can still be placed on the forearm. Make sure that there are no debris or brim on the forearm/hand. Otherwise you could break the hand!
• If the repulsor is semi-transparent, simply paint it with a paint pen before or after gluing