Download V2 of the slide to get a slide that sits completely flush with the flappy door eliminating any step filament can get tangled on.
Remix of @Krall3 poop cover.
I had the issue that purged filament sometimes got tangled around the flappy door in the poop chute to further get stuck. Sometimes the purge did not get loose and the poop chute filled up completely with filament until the printer paused until the chute was cleared by me.
Especially on long PAHT-CF, ASA or ABS prints with lots of filament changes for interface material the poop chute clogging can be a problem since you can`t open the door unless you want your part to warp. I also think its going to be handy for long PLA prints with lots of color changes.
The Poop Chute Slide is easy to print without any supports. I advice to cover it in aluminum tape so no filament can stick to it. If you are going to use the Slide in a hot chamber I at least would print it in PETG (which works for me in a 60°C chamber for 24h+ print), but better will be ASA or a filament which has even better heat resistance.
To cover the Poop Chute Slide with aluminum tape, lay down a stripe on your working surface. Then place the Slide on it.
Step 1:
Step 2, flip it 90°:
Step 3 (optional), place two little heat resistant parts of tape on the red circled areas to make it stay in place even better:
Step 4, push the Slide into the poop chute (quite tight fit) and push it into place. Check whether the black wiper in the back still can move free without knocking on the Slide:
I hope this will also come in handy for others. Use on your own risk :)