This is a stand for the Lenovo Legion Go. The intended use is to bring the Legion Go just above mixer/controller height. However, you can use this stand however you wish.

Some assembly is required. Please use the example photo for top and bottome placement. You will need 4 M3X8 Coarse Thread Screws, 4 M3X18 Screws with 8 matching Washers, and 4 matching Nuts. The larger tube joining the two bottom portions is held on by the 4 M3 Screw combo. The plugs are held in using the coarse thread M3 screws. Careful when screwing these in, as overtightening will strip the material. These can also be glued in place, but ensure not to get glue in the areas contacting the tubes.

This is version 1. As such, things may change in time. Feel free to remix this or leave comments for improvements you would like to see.

Happy Printing!