Toyota GR Supra MKV Magsafe Phone Mount

Copyright Claim

Toyota GR Supra MKV Magsafe Phone Mount

Boost
3
2
2

Print Profile(1)

All
P1S
P1P
X1
X1 Carbon
X1E
A1

0.2mm layer, 4 walls, 15% infill
0.2mm layer, 4 walls, 15% infill
Designer
1.4 h
2 plates
5.0(1)

Boost
3
2
2
2
3
2
Released

Description

This is a simple Magsafe phone mount for the MKV Supra. There are two models available:

  1. Flat
  2. Angled

The mount clips into the grooves on the dash as shown in the installation video below.

You will need to buy a ring magnet to attach to the mount. If you don't have a Magsafe phone/case already, you'll need a ring magnet for your phone also. The ones I linked are cheap and arrived relatively fast for me. I did add a bit of superglue to the mount before placing the adhesive side of the ring magnet in place just in case it wasn't strong enough to hold the magnet in place.

 

I did notice when mounting it in different spots that the dash is not perfectly consistent and some spots are a little tighter than others. I made it so that it can still fit in the tight spots with a little extra squeezing but still be secure in the looser spots. Not sure if different cars will be much different but I'm assuming it should be pretty close.

Comment & Rating (2)

Please fill in your opinion
(0/5000)

Boosted
Print Profile
0.2mm layer, 4 walls, 15% infill
printet in Asa and it came pretty solid👍🏼 Still waiting on Aliexpress Mag safe Ring.
The designer has replied
0
Reply
Looks good! The original I made is still holding up perfectly.
0
Reply
No more