Introducing the Monitor Light Bar
- your ultimate companion for immersive and glare-free computing experiences
Placed on top of your monitor, this light bar casts a gentle, downward flow of illumination onto your workspace, effortlessly eradicating shadows and banishing eye strain.
Designed to have an indirect illumination which ensures a uniform light distribution, bathing your desk in a soft, diffuse glow without a hint of harshness. Designed to prevent reflection on your monitor screen, allowing you to focus intently on your tasks without distractions.
The monitor light bar can be configured as desired:
300mm
400mm
500mm
or mix the tubes as it fits your needs.
Illuminate your workspace with brilliance and finesse.
PS. if connected to one of USB-ports on the monitor, it will turn on and off with the monitor/computer.
What you need:
The printed parts
1 M3x35mm fastener
1 M3 nut
LED strip
Wire
Power supply
Heavy material (sand, rucks or ?)
Tin foil
Glue
Screwdriver
Soldering iron
Scissors/knife
Step 1
Glue the tin foil to the inside of the tube, opposite side of the holes.
and trim it
Step 2
Glue the alignment pins in to the center tube
Step 3
Glue the 3 tubes together
Step 4
Measure and cut the LED strip and wire to size
Step 5
If not using a USB cable or other small connector, remember to feed the wire through here now
Step 6
Feed the wire through the light bar and solder it to the LED strip
Step 7
Glue the LED strip to the light bar (as far up/as close to the tin foil as possible)
Step 8
Put on the end caps
Step 9
Fill the container with a heavy material (I used sand)
and put on the lid (might be a bit snug)
Step 10
Screw the items together
Step 11
Assemble the 2 parts together
Step 12
Place it on your monitor and enjoy :)