Simple Helmet Stand with Base
Remixed by
Simple Helmet Stand with Base
Remixed by
Boost
17
26
3
Print Profile(1)
0.28mm layer, 3 walls, 15% infill
Designer
9.9 h
2 plates
Boost
17
26
3
0
64
44
Released
Description
This adds a round base to the simple helmet stand from @SuperheroDIY on Printables. The base helps lift the stand a bit more off the table surface. The print file has also been sliced to fit on Bambu printers.
Comment & Rating (3)
All
Print Profile
0.28mm layer, 3 walls, 15% infill
This printed very well and very easily, but after I was finished it was too short. Not the prints fault but mine for not paying atterntion. Still 5 stars and I'll find a use for it. Thank you
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.28mm layer, 3 walls, 15% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld