Simple Strong Display Case Riser Stand for IKEA KALLAX & DETOLF Bookshelves and Display Cases
Simple Strong Display Case Riser Stand for IKEA KALLAX & DETOLF Bookshelves and Display Cases
Boost
16
24
1
Print Profile(1)
0.28mm layer, 3 walls, 10% infill
Designer
9.9 h
1 plate
Boost
16
24
1
0
46
12
Released
Description
These are simple risers designed to fit Ikea Kallax bookshelf and Detolf display cabinet. Each riser is 6.5" W x 5" D x 4" T. Two of them side by side fit just inside a Kallax shelf width-wise with a bit of wiggle room. The triangular shape on the bottom is to make sure the PLA doesn't cause warping and sagging over time. It still prints without support.
Comment & Rating (1)
All
Print Profile
0.28mm layer, 3 walls, 10% infill
Nice print. Has held up well. Thank you.
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld