RCD Tree N.1 for 32mm Scale - H0 Scale - N Scale

Enhance your railway diorama (H0 and N Scale) and tabletop game scenery using this tree.

To achieve the final results shown in the pictures 4 additional steps are required:
1. Prime the entire tree.
2. Quickly colour the branches and the trunk with the desired colour.
3. Attach smaller branches using hot glue. I used Seafoam trees.
4. With spray glue, I sprinkled micro leaves on the seafoam trees using two different shades. The darker shade is on all the seafoam trees, while the lighter shade is only on the top as if the light of the sun is hitting the tree from one direction.

Enjoy!

For more designs visit my page on Cults3D
[https://cults3d.com/@RiverCrossDiorama]

If you like what I do and would like to support me:
Buymeacoffee [https://www.buymeacoffee.com/rivercrossdiorama]

Ko-fi [https://ko-fi.com/rivercrossdiorama]

Linktr.ee [https://linktr.ee/rivercrossdiorama]

[Cheers!
RCD]

Due to the different orientations of the branches, which are required to achieve a realistic effect, this print necessitates support.
I printed the tree both on a Bambu X1C and a P1P. I tested the supports on Bambu Studio software, and I used the tree support function, removable on Tree Slim mode. This allows to waste less material than normal supports and it's way easier to remove them with a modelling cutter. If some branches detach because you apply too much force while removing the supports, just use hot glue to attach them again to the tree.