Print at 100% infill with a layer height of 0.04mm with a base layer of 0.24mm
Filaments Used:
PLA+ Sunlu Black Transmission Distance: 0.6
PLA+ Sunlu Grey Transmission Distance: 2
PLA+ Sunlu Silver Transmission Distance: 2
PLA BambuLab Magenta Transmission Distance: 3
PLA BambuLab Matte Sakura Pink Transmission Distance: 3
PLA+ Sunlu White Transmission Distance: 5
Swap Instructions:
Start with Black
At layer #8 (0.52mm) swap to Grey
At layer #15 (0.8mm) swap to Silver
At layer #28 (1.32mm) swap to Magenta
At layer #38 (1.72mm) swap to Sakura Pink
At layer #46 (2.04mm) swap to White for the rest.
please follow the settings in the bambu wiki seen below for best Results.
(1) Adjust the min layer height to 0.04 mm.
(2) Confirm specific process parameters