60mm Rotiform wheel center cap, direct fit
Copyright Claim
60mm Rotiform wheel center cap, direct fit
Boost
3
4
3
Print Profile(1)
0.2mm layer, 5 walls, 25% infill
Designer
24 min
1 plate
Boost
3
4
3
0
21
17
Released
Description
I made this cap to replace the one that got away.
The print plate is for the flat cap but if you, like me, went back and found the rotiform aluminum brand cover, I've also included a version with a ridge for it to wrap around with tape/glue as the original had.
Comment & Rating (3)
All
Print Profile
0.2mm layer, 5 walls, 25% infill
Good solid cap and design. For my application i ended up scaling the cap to 59mm x 59mm which ended up being ideal. 60mm was just slightly too large to fit without risk of breaking cap.
(Edited)The designer has replied
0
Reply
I'd suggest that your original cap may have not been 60mm in this case, or your filament hasn't been calibrated as that can make up the 1.7% difference. I've printed a few for friends and the fit has been good, but I'm glad it worked for you in some capacity!
0
Reply
Print Profile
0.2mm layer, 5 walls, 25% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld