Counter Cleaner Remix: Under Counter Bin
Remixed by
Copyright Claim
Counter Cleaner Remix: Under Counter Bin
Remixed by
Boost
11
35
9
Print Profile(2)
"Wide" 0.2mm layer, 2 walls, 10% infill
Designer
4.2 h
1 plate
0.2mm layer, 2 walls, 10% infill
Designer
4.4 h
1 plate
Boost
11
35
9
0
50
38
Released
Description
A remix of Cookiedeluxe's Counter Cleaner, designed to slot past the edge of the counter so that no crumbs/debris fall between the cleaner and the counter.
There are two versions, a “standard” opening of about an inch, and a “wide” version that is twice as wide (about 2").
Original model found here: https://makerworld.com/en/models/188957#profileId-212942
“This Counter Cleaner helps you to easily, quickly and thoroughly clean things off your kitchen counter / dining table / office desk. Just place it against the counter or table, sweep everything into it and you're done!”
Comment & Rating (9)
All
Print Profile
"Wide" 0.2mm layer, 2 walls, 10% infill
I like the design. I tried printing this remix and the original at least four times. I tried it with glue/without gllue and with a brim/without a brim. I finally got it to print right with glue and an inside/outside brim. After all that it did not clean up right and has rough edges. I may try it again.
(Edited)
0
Reply
Print Profile
"Wide" 0.2mm layer, 2 walls, 10% infill
printed great and works great
0
Reply
Print Profile
"Wide" 0.2mm layer, 2 walls, 10% infill
Printed easily, works perfect, thank you!
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
supports popped off with no issues
0
Reply
Print Profile
"Wide" 0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
Support Issue
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
"Wide" 0.2mm layer, 2 walls, 10% infill
0
Reply
Print Profile
0.2mm layer, 2 walls, 10% infill
0
Reply
No more
This remix is based on
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld