Raspberry PI 5 Case with Geekworm X1001 NVME Top Hat by Manfred Schreiber

Manfred Schreiber

Hobby & DIY>Electronics

Print Profile(1)

All

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

1.5 h

1 plate

4.0(2)

Boost

Released

Description

This is a simple case for the Raspberry Pi 5 with the Geekworm X1001 NVMe HAT and the original Raspberry Pi fan. The case features an integrated reset button and a closure for the SD card slot. The following parts are required for the case:

1x Melting nut M2.5X4X3.5
2x Melting nut M2.5X6X3.5
4x Screws M2.5X8mm

Additionally, the screws supplied with the Geekworm X1001 NVMe HAT are also needed. Since inserting the reset button can be quite fiddly, several extras are printed as replacements.

Comment & Rating (3)

@user_633866474

Print Profile

0.2mm layer, 2 walls, 15% infill

the top of this part was white and the bottom was red. the system should have printed all the red first then the white. instead it almost every layer changed out the spool to the other color. it wasted a lot of time and material.

(Edited)

The designer has replied

@ManfredSchreibe

This profile is only available in one color. The color blue is preset here, but can be changed very easily. All parts have the same color, so it is not necessary to constantly change the filament.