No Print Profile yet. Add one to earn points.
Useful for CNC plasma cut tables, CNC routers, CNC mills, etc. Snap-on top allows opening for wire insertion. (v1.13)
Two of my recently posted videos feature this same design in actual use on my CNC plasma cutting table, which is based on the LowRider v3. See them below. The second one below shows detail on how I use this drag chain for both X and Y axes on the LowRider 3 that I'm using for plasma.
This also pairs with this: lowrider-3-plasma-cnc-drag-chain-mount-revised-for [link pending]
Larger sized drag chain for CNC plasma cut tables, CNC routers, CNC mills, power, data, coaxial, and other cables/cords.
This is a two-piece, snap-open drag chain, with an inside track dimension of 20mm x 40mm, and it's designed for a 64mm radius. As such, it should aid in protection against strain for wires/cables that should not be bent in curves tighter than 128 mm in diameter.
It's optimized for 3D printing, and prints with no supports needed.
Printer Settings
Printing Tips
A given printer’s calibration has an impact on how straight of a line the drag chain (cable chain) holds when suspended. If you find (after printing a batch of the chain links and assembling) that you have some sag, use your printer’s percentage settings to increase flow. If the batch won’t quite lay straight, do the reverse, reducing flow. I would think 3-5% at a time, depending on how far off perfect it is. Maybe only 1-2%.
Also, I had my best success at getting the clips printed (the snap-on tops) by printing a whole sheet of nothing but them. For some reason my attempts to print the clips along side the chain links, resulted in the clips separating from the bed and just being a lost part of the print. Thanks to them not being a lot of grams worth, there was not much “spaghetti.” I allowed those flawed print jobs to complete because the chain links were still good.
Prepping the bed with a coating of hairspray first is probably a good idea. That and making sure the Z height is zeroed in for that all-important first layer.
FAQ
Illustration: chain links oriented all same way with columns “nested” into each other for maximum use of the printer bed:
Illustration: chain links oriented in all four directions to protect against the printer being off somewhat:
Change log:
My PayPal tip jar: https://paypal.me/design8studio
Various LowRider 3 CNC remixes:
View all my models and remixes:
*Amazon product links are affiliate links.