USB Hole cover for P1P/P1S
Copyright Claim
USB Hole cover for P1P/P1S
Boost
7
14
9
Print Profile(1)
0.2mm layer, 3 walls, 15% infill
Designer
7 min
1 plate
Boost
7
14
9
0
58
34
Released
Description
Quite stiff in place cover for USB hole on top of P1P and P1S printer.
I used PLA for this, but other filaments might work as well.
Comment & Rating (9)
All
Print Profile
0.2mm layer, 3 walls, 15% infill
fit perfect. Petg cf
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Der wohl kleinste Druck bisher
0
Reply
Piece printed quick, and clean! Fit into the slot without any effort.
Only issue I see is - how do I remove it? I've tried reaching inside to try and push it out from the bottom since it is flush at the top, but no luck. I have yet to try and pry it with something thin, but I don't mind leaving it in there to stop the dust entering the hole.
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
Klein aber fein, vielen Dank
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 3 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld