Travel Cutlery Set _ Kit Card
Copyright Claim
Travel Cutlery Set _ Kit Card
Boost
93
84
6
Print Profile(1)
Travel Cutlery Set 0.16mm layer, 4 walls, 15% infill
Designer
1.8 h
1 plate
Boost
93
84
6
0
123
58
Released
Description
This Travel Cutlery Set is designed to be conveniently carried, for example, in a backpack when hiking.
The cutlery can be snapped together using the lock system. This keeps the cutlery together.
Comment & Rating (6)
All
Print Profile
Travel Cutlery Set 0.16mm layer, 4 walls, 15% infill
Printed half size just for fun. Works. Knife has trouble sliding, but that might be because I reduced everything 50%
1
Reply
Print Profile
Travel Cutlery Set 0.16mm layer, 4 walls, 15% infill
hahah stirred some meals while camping after dumping hot water in it, went limp like a noodle.
still was an awesome print worked well, glad I could do it, but pla gets hot it goes limp, 😭😭😘😘 not the modelers fault
The designer has replied
1
Reply
The PLA print is more suitable for cold dishes. If you want to make full use of the cutlery, you can print it from Fillamentum Nonoilen, for example. :)
0
Reply
Print Profile
Travel Cutlery Set 0.16mm layer, 4 walls, 15% infill
Printed ok.
0
Reply
Print Profile
Travel Cutlery Set 0.16mm layer, 4 walls, 15% infill
Build works great. There are some support artifacts within the spoon, but these are relatively inconsequential.
0
Reply
Print Profile
Travel Cutlery Set 0.16mm layer, 4 walls, 15% infill
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld