This is a pyramid holder for your Rubik's Cubes, and it will fit 2x2, 3x3, 4x4, 5x5, Skewb and other similar sized cubes. Up to 10 cubes can be stored in this holder. Compared to other stands of similar concept, I've made this significantly deeper, to provide better support for the cubes, and the construction is very stable.

The total width is around 35cm, so it's broken into two parts, and both are in the same STL-file. Just load the file into your slicer, delete one of the two parts and print it. Then load it in again, delete the other part and print it. 

When you have the two parts, it's time for gluing. I used standard super glue, and my stand has held for several months now. This is due to the pressure from the weight of the cubes being downward, which strengthens the assembly. 

If you experience an issue where the cubes slide out of the holder too easily, just use a bit of normal transparent tape on the holder's contact surfaces, to increase friction - as plastic against plastic is very slippery.