Dawn of the dead Goerge A Romero movie poster fridge magnet
Boost
20
15
10
Print Profile(1)
0.08mm layer, 2 walls, 15% infill
Designer
2.4 h
1 plate
Boost
20
15
10
1
20
12
Released
Description
A Dawn of the Dead George A Romero movie poster fridge magnet.
4 colour AMS print, using black, red, lemon yellow and white.
This needs 4x 8mm diameter by 2mm deep magnets, the magnets push into the model after printing, no need to pause.pause..
NOTE - The magnets are designed to be a tight fit. The best way to insert them is to line up a magnet with a hole then place the model on a hard flat surface facing up, with the magnet on the hard surface, then press down firmly on the model. The magnet will snap into place. Repeat for each magnet.
Comment & Rating (10)
All
Boosted
Print Profile
0.08mm layer, 2 walls, 15% infill
One of my favorite flicks is now one of my favorite prints.
The designer has replied
1
Reply
Thank you for rating, it's one of my favourite movies too 😊
0
Reply
Magnets don't fit, bought the exact dimension you listed
Hole internals are uneven due to poor bridging inside. Any ideas?
The designer has replied
0
Reply
Hi,
I've printed over a dozen of these and the magnets always fit for me though they are a tight fit (intentionally, I don't want them falling out).
They way I get them in is to line the magnet up with the hole, then place the model on a hard flat surface facing up, then press firmly down on the model and the magnet snaps into place.
I hope that makes sense
1
Reply
Replying to @crabstiks
I'll have to try to post a Pic of inside the home for reference but I've tried that, I will try it tonight harder as I felt like I was going to break it
I understand your process but it seems like it's almost impossible to get the magnet to sit inside flush, I wouldn't mind super gluing it if necessary. Worst comes to worst maybe I can scale up 1% or so to make them fit inside and glue them?
0
Reply
Replying to @PupaePrint
I'm not sure scaling up will work as it might affect the picture, it has very fine tolerances.
A better solution would be to add a negative cylinder of the size you want (example 6.4mm... My holes are 6.1mm diameter and 2.2mm deep) and line them up with the existing holes
0
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
1
Reply
Print Profile
0.08mm layer, 2 walls, 15% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share Alike
© 2024 MakerWorld