Yubikey 5C NFC Key Fob Case Schlüsselanhänger by winni118100

winni118100

Tools>Gadgets

Print Profile(1)

All

A1 mini

P1S

P1P

X1 Carbon

X1E

0.2mm layer, 2 walls, 15% infill

Designer

19 min

1 plate

4.0(3)

Boost

Released

Description

I needed a key fob for my Yubikey.
I printed a version without a support structure, but unfortunately it was a lot of work to get the incorrectly printed filament out of the key fob. It works best with a support structure. It's best to use thin pliers to pull out the supports.

Comment & Rating (5)

@user_487660009

Boosted

Great model. Thx.

@raphty

Print Profile

0.2mm layer, 2 walls, 15% infill

I found it to be too thick, reaching the button is too hard, and getting it onto the key ring is also made much more complicated. in addition, I would recommend flipping the model and using tree support, makes for a cleaner print and less annoying to get the support out.

@tfridley

Works well! Make sure you get all of the support interfaces out of the print as well or things will not slide. After that just exercising your YubiKey a few times will get it to a point it slides fairly easily, but won't slip on its own.