Low Poly Version Rocket Money Savings Piggy Bank

Imagine a million years lost in space and time, after crashing through a vortex of loose change it has transformed my original creation into a stealth low poly rocket bank. Be warned it's a bit battle scarred and dented but still holds your valuable loot. So get saving and you too could be flying off to the far side of Helix Nebula.

I printed this at .15 layer height but .20 should work, add supports to the wings and the main body may require supports for coin slot. For a two colour body add colour change at 110mm in your slicer.

You can print the Wing Thrusters and Body Plug all at the same time.

Assembly Required - I recommend using super glue or 3d gloop.

Glue Thrusters into bottom of wings and glue wings to rocket body.

Tolerance is tight and may need slight post production.

Print one for your friends and family, it's a great and fun way to encourage children to start saving!

All my designs and images used are not commercial free and are copyright of ©D3DCreative

By downloading my models you may not share any of the Images/STLs/GCode etc to any other persons or platforms e.g. thingiverse/makerworld

By downloading my work you agree to the above terms set out by me.

Check out the original version here https://cults3d.com/en/3d-model/various/rocket-money-savings-bank

Nozzle: 0.4
Layer Height: 0.15 or 0.20
Supports: Main body may need supports for coin slot.
Wings need supports.

For two colour body adding a colour change at 110mm works well.

Print 3 x Wing and 3 x Wing Thruster

Assembly Required - use super glue or 3d gloop