PIP BOY X1C
Copyright Claim
PIP BOY X1C
Boost
129
142
21
Print Profile(2)
0.2mm layer, 3 walls, 5% infill
Designer
8.7 h
1 plate
0.16mm layer, 3 walls, 15% infill Gyroid
11.2 h
1 plate
Boost
129
142
21
0
145
38
Released
Description
The PIP BOY for the X1C, working great as you can see on my picture.
Adjust it, remix it as you wish, this is just a try-out.
Comment & Rating (21)
All
Print Profile
0.2mm layer, 3 walls, 5% infill
Great profile. added needles ro the dials with some filament shavings
The designer has replied
0
Reply
Wow, that is looking awesome :-)
0
Reply
Printed with support. Set layer height to .16 with the X1C 0.4mm nozzle. Looks and feels amazing! Thanks so much for this :) <3 ❤️
The designer has replied
0
Reply
Looks amazing :-)
1
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
my screen look more exciting now !
(Edited)
0
Reply
fun little project
0
Reply
you should make one for the p1p and the p1s and call it the P1P boy.
The designer has replied
0
Reply
There is already one on Makerworld
0
Reply
Replying to @DutchWorkX3D
i cant find it, can you link it?
0
Reply
Replying to @Slid3r85
https://makerworld.com/en/models/135140?from=search
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
The designer has replied
0
Reply
That looks awesome :-)
(Edited)1
Reply
I am about to print this! Any suggestions on settings to increase the quality so its not so rough on the outer edging?
The designer has replied
0
Reply
I used a 0.6mm nozzle, but there are many options, speed, walls etc.
0
Reply
Replying to @DutchWorkX3D
I'll be using a .4. Should be much finer on the detail then. Here we go! I'll post after.
0
Reply
Print Profile
0.16mm layer, 3 walls, 15% infill Gyroid
wA laU Eh si bei hoh eh
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
0
Reply
Print Profile
0.2mm layer, 3 walls, 5% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld