This is custom made 3/8 drive socket used for assisting in getting certain headlight bulbs out of a vehicle that is hard to reach or to remove. I work for an auto Parts store and have noticed time and again there are certain cars that give you no room for you to fit your hand into , so you remove the headlight bulbs out.
This socket is designed to grip the base of the head bulb on the assembly and carefully remove it with the leverage of a ratchet. It's easy to use and found it useful in times where finger strength fails.
This is a great product for people that are into cars or would like the solution to this problem.
Supported headlight bulbs that fits onto this socket are listed below:
H8
H9
H10
H11
H12
H13
9005
9006
9012
Other headlight bulbs that are not listed above are not supported at this time. I will be developing more sockets for these soon.
This model have been only tested with PLA Filament is REALLY STRONG.
Settings I used in slicer were .2 layer height and 100% infill with the rest of the settings default to your machine. In my case, my model was printed using my Ender 3 v2 neo.
100% infill is recommend if you going to use PLA as your filament. It will be strong enough to handle the pressure.
If you have any questions Feel free to contact me .