Roland Street Cube EX Amp Attachment Mic Holder

"Attachment with Mic Mount for Roland Street Cube EX"

This popular mic mount is specifically designed for the "Roland Street Cube EX" stereo amp, favored for street performances! 🌟

With just a Phillips screwdriver, anyone can easily attach it.

When you're not using your microphone, where do you usually place it? With this mount, you can conveniently store your mic in a space-saving and secure manner!

The microphone shown on the right side of the photo is a SHURE 58 microphone, and the mount accommodates mic sizes of average dimensions.

Here are the instructions for installation:

① Attach the mic mount to the amp body using one of the screws on the grill!

② Remove one screw from the top left and right of the front of the amp.

③ Insert the screw into the hole of our product (the mic mount) along with the washer.

④ Tighten the screw back into its original position, and you're done!

(Note: Using a screw of 4mm or less allows you to attach it anywhere, such as on wooden parts.)

◆Product Size
Thickness: 1.61 inches
Total Length: 2.13 inches

Screw Mounting Part
Height: 0.83 inches
Width: 1.38 inches
Thickness: Approximately 0.79 inches

Microphone Attachment Part
Outer Diameter: 1.06 inches (max)
Inner Diameter: 0.91 inches (max)

※The photo demonstrates an example of the attachment being mounted on both the left and right sides.

Layer height: 0.2-0.25mm
Infill: 25-30%
Material: PLA
Supports: Partially required, for screw holes

Printing the object in the opposite direction of the installation example will result in a stronger print with better structural integrity.