Inland Refill Spool Adapter For Bambu Spools (Microcenter) (Bambulabs) (Filament)
Copyright Claim
Inland Refill Spool Adapter For Bambu Spools (Microcenter) (Bambulabs) (Filament)
Boost
2
6
4
Print Profile(1)
(NEW V2) 0.2mm layer, 4 walls, 4% infill
Designer
1.3 h
1 plate
Boost
2
6
4
0
13
16
Released
Description
* V2 Update to fit better, index easier, and print faster.
Prints in (1h17m) using (78.01g) of filament
- 0.20mm Standard
- (4) Wall loops
- (0) Top shell layers
- (0) Bottom shell layers
- (4%) Sparse infill density
- (Honeycomb) Sparse infill pattern
Thank you for the feed back.
Comment & Rating (4)
All
Print Profile
(OLD V1) 0.2mm layer, 3 walls, 7% infill (Top and Bottom Walls NOT DELETED) (Spare Profile)
file was good I had a little problem getting it to lock in I’ll have to scale it a little thinner on the width to get it to work !
(Edited)
The designer has replied
1
Reply
Thanks for the feedback. I'll upload a V2 implementing your change as well as adding more index slots-- on both faces, FOR ease of use.
Check back in 12 hours. :)
0
Reply
V2 is up! Thank you again.
(Edited)1
Reply
Print Profile
(NEW V2) 0.2mm layer, 4 walls, 4% infill
Adjusted for a .6mm cht nozzle, printed great. Inland red pla
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution
© 2024 MakerWorld