As I was repairing and refurbish a used “Gusak” Takara Tomy Mechanical Model, I noticed that the part 'A-4' was missing from it.
So, I went on to Fusion 360, and using reference imagery, I quickly whipped up a replica for it and printed it! It was a success!
I would advise to do some initial filing/sanding in the fitting groove on the underside as the tolerances are quite tight, but it is meant to be glued in place inevitably.
Of course you'll get a higher definition of it through Resin Printing, but I succeeded in printing it in FDM just fine as well!
I hope this is of help to many fellow Zoids fans!