This model is remix of two older models that I found on Thingiverse.
The first is a Teddy Bear - its located here → Teddy bear by suzujoji - Thingiverse and was published 15 years ago. I've included the original stl in the print profile, as well as my remix. The remix is very minor, I flatten the bear's bottom so that it sat flush on the car seats in the remixed car. The bears have been a big hit with my little girls.
The second is a Peppa Pig car - its located here → Peppa Pig - Car by sam5400 - Thingiverse. My girls liked the car and by chance it was small enough fit on my Mini's print plate, but large enough to fit four bears. The original car is included. The remix consisted of:
For assembly - put the wheels on the axels then glue them in the slots provided underneath the car chassis. Then glue the seats in. The rear seat sticks to the rear wheel arches and the front seat can be glued along the raised ridged on the floor. I didn't glue in the windshield, in case my girls broke it.
I hope you enjoy both remixes.