I remixed @Printit's design originally used for the RG353M to fit the RG35XX H
I also stripped the branding so it would work better printing patterned shells, using high temp patterned heatbeds as shown in photos.
[Note: the pattern shown is the photo is achieved with a specific heatbed, and is not a part of the design]
The design boasts slim sturdy hinge, single latch securing system, cutout for USB-C charging while in the case, inner shell indentations for a snug fit.
________
What you will need for this print:
• Self Adhesive Sticky Back Multipurpose Felt Sheet (1.5mm thickness - 2mm thickness) cut to size
• Normal 3d printer filament for the Hinge joints (1.75mm)
• Nail Clippers or wire cutters to snip the filament after you pass it through the hinges
_________
Comment like & Share if you enjoyed the design
Happy Gaming :)