u joint that can move like a u joint but not handle stress like a u joint
used on vehicle driveshafts
has built in lock collars on the end of yokes, uses 1/8 in fine thread bolt at 1:1 scale.
1:1 scale has a 0.75" bore on the yokes, and has 12 splines.
Snap rings do NOT fit on 1:1 scale.
how to assemble:
- print 2 yokes, 1 cross, 4 caps, and optionally 4 snap rings
- make sure caps fit onto cross and into yoke holes, if not you will have to sand them
- put caps into yoke slots, make sure they are mostly sticking out
- put cross in between the caps and push caps in
- put snap rings, if you printed them, into little slots in the yokes. The snap rings hold the caps into place so they don't slide out.