This is a simple coin sorter for USA money (USD) to help you separate coins. You take a few coins at a time and they slide down the chute and will usually fall into the correct hole. This makes it easy for wrapping or counting. There are some markers etched into the design, but I recommend making your own lines/marks where it makes sense for your needs.

This print profile is based on Improved Auto Coin Sorter V7.5 - "Short" US Dollar Version by Bikecyclist. There are no major revisions here, but Icreated some ready to go print profiles for beginners or Bambu Handy users since I did not yet see anything like this on Maker World yet (many things for Euro coins, but not USD).

There are two print profiles. One includes the sorting tubes, which I don't find necessary, but are included here since they were available in the original. Everything prints on one plate for my P1S.

I found that the penny vs dimes sorting was generally good on this model.

Important Note: Make sure the top piece is attached as a significant angle, it should be connected in a T. When it is in the right position there will be a bit of a snap. If you don't seat it fully down, coins are more likely to become stuck on the top of the back piece. See the photos for a comparison.