Transform your motorcycle's OEM square headlight into a powerful 7-inch LED headlight while seamlessly integrating the fuse box into the headlight housing with this innovative headlight bracket.
Installation Instructions:
- Begin by securing all nuts into their respective recesses using glue. Allow them to dry completely.
- Install the headlight into the retainer, ensuring alignment with the head sync on the rear of the headlight. Slightly bend the bracket into place if needed.
- Slide the headlight and retainer assembly into the headlight bucket, where the retainer will seat against the protrusions to prevent shifting or tilting during use.
- Attach the fuse box to the back of the headlight bucket.
- Once assembled, mount it onto your bike using your preferred aftermarket bracket. The bolts should align perfectly due to the alignment protrusions.
Printing Recommendations:
- PETG material is recommended for optimal durability and warp resistance. You may also use PLA + for the internal bracket.
- Use a minimum of 35% infill, 50% is recommended.
- Print the headlight bucket face down with support.
- Print the retaining ring face down.
- Print the bracket on its side with supports (refer to the last photo for details).
Required Hardware:
- 2x M7x20mm button head Allen bolts for the headlight.
- 2x M7 nuts (approximately 13.7mm in diameter to fit inside the recesses).
- 2x M4x10mm button head Allen bolts for the fuse box.
- 2x M4 nuts (approximately 7.5mm in diameter to fit inside the recesses).
For securing nuts into the plastic, it's recommended to use Super Glue or Gorilla Glue for a secure fit.
Experience enhanced lighting performance and streamlined design integration with this headlight bracket upgrade.