Third version of yin yang, this time with bees,

they are special to my mom, so i decided to give it to her as a gift

*created with filament painting technique using hueforge software.

Remember if you want to scale, do it only with x and y axis, z must be the same as original.

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black
PLA BambuLab Matte Mandarin Orange
PLA BambuLab Basic Yellow
PLA BambuLab Basic Jade White

Swap Instructions: if you don't have ams just put pause on specified layers and swap filamen manually
Start with Black
At layer #6 (0.56mm) swap to Mandarin Orange
At layer #15 (1.28mm) swap to Yellow
At layer #19 (1.6mm) swap to Jade White for the rest.