Flsun V400 Fleximount Final Edition!

English:

Correction: access to top usb port cleared.

The reworked optimized last version of my first rotativ Speederpad mount.

Printed it with Black PLA+.

Layer height : 0.2 ; Width: 0.4

Walls : 2 ; Wall ordering : From outside inwards

Layers : Top: 3 ; Bottom: 3

Infill : 20% Lines

Temp : Nozzle : 200 ; Bed : 60

Speed : Default Cura settings (400) ; First layer : 25

Supports are needed. Very little post work. Tree ; To bed. - Noticed that Cura 5.6.0 sometimes bugs with tree supports, if you use Cura and have this issue give it a go with version 4.13.1 and it will work fine.

No brimm

Please know that those parameters worked fine on MY V400 with a tolerance of 0.2mm, but may not on yours.

Mount Clip credited to @YosiYaffe https://www.printables.com/@YosiYaffe was a huge time saver.

Note that you can reverse the mount clip to make it face where you need.

To rotate just unscrew a bit & tighten again.

Spent a lot of time refining this one to the best.

Any suggestions? please do! Any comments or issues? I'll help with pleasure!

Hope you like it!

If it's the case, please push the like button and if you would like to buy me a coffee (link on profile) would be much appreciated!

French :

Correction : Top usb port now free.

The reworked and optimized version of my first rotating mount for the Speederpad.

Printed with PLA+ Black.

Layer height: 0.2; Width: 0.4

Walls: 2; Wall order: from outside to inside

Top/Bottom layers: Top: 3; Bottom: 3

Filling: 20% lines

Temperature: Nozzle: 200; Tray: 60

Speed: Cura default settings 400; First layer: 25

Supports are required. Very little post-processing. Tree structure; Plate contact. - I've noticed that Cura 5.6.0 sometimes has bugs with tree brackets, if you're using Cura and encounter this problem, version 4.13.1 will work just fine.

No adhesion.

Please note that these parameters worked well on MY V400 with a tolerance of 0.2 mm, but perhaps not on yours.

To turn your pad, simply unscrew a little and then retighten again.

Mount Clip by @YosiYaffe https://www.printables.com/@YosiYaffe was a huge time saver for me.

Note that you can invert the mounting clip to place it where you need it.

I spent a lot of time tweaking this one to the best of my ability.

Any suggestions? You're welcome! Any comments or problems? I'll be happy to answer and help!

I hope you like the idea!

If you do, feel free to press the Like button and if you'd like to buy me a coffee (link on profile), I'd really appreciate it!

• Layer height: 0.2; Width: 0.4

• Walls: 2; Wall order: from outside to inside

• Top/Bottom layers: Top: 3; Bottom: 3

• Filling: 20% lines

• Temperature: Nozzle: 200; Tray: 60

• Speed: Cura default settings 400; First layer: 25

• Supports are required. Very little post-processing. -Tree structure; Plate contact. - I've noticed that Cura 5.6.0 sometimes has bugs with tree brackets, if you're using Cura and encounter this problem, version 4.13.1 will work just fine.

• No adhesion.