Hey guys I found that using the meter holder for the hydra mod ( https://www.printables.com/model/423765-silica-dry-box-for-bambu-lab-ams-hydra-and-stock-v ) Was reading lower then it actually is in my ams because its right at the source of the silica so I modeled up some spool mounts for the outside of your spools. You can combine these mounts with the model above and this here https://makerworld.com/en/models/102120#profileId-111638 to draw your moisture down quite alot. I used these specific meters. https://www.amazon.com/dp/B08PVBX7PN? The fit is slightly loose on the meters because they are not manufactured consistent. If they are too loose you can run a small line of tape around your meter or use the included files to slightly tighten the fitment.