Holder for Dremel 4250 to be fitted on Honeycomb wall. Probably will fit another models like 4000-ish or 3000 but that's not for 100% sure. I Made a separate rail for cable as well. made from 2 parts. Not sure why, but just liked the idea. And separate cable locking piin to be put anywhere you want on the wall. After some test i found that this Dremel holder is sturdy enough so You can even use it in holder if you have a flexible shaft. Only thing as I didn't design it for that purpose, probably Dremel will heat up as there are no vents in holder. So a bit later I will make a new version with them as well.

Supports needed only for cable Holder bracket. As on Picture best placements on bed when slicing are standing on inserts or lying on side. I used second variant with tree supports and it did printed fine. only a bit harsh to get supports out from sliding rail. Just took a hobby knife and cut them from both sides (walls) and they should tear then off easy. 

You can Buy me a coffee if You feel good doing so :) (And very big Thank You For interest in my work)
https://www.buymeacoffee.com/warlogh