Clean Cable Management Organizer Clip
Copyright Claim
Clean Cable Management Organizer Clip
Boost
87
182
16
Print Profile(3)
0.2mm layer, 2 walls, 15% infill
Designer
45 min
1 plate
organizer for 8 cables
Designer
40 min
1 plate
A1 mini, 0.2mm layer, 2 walls, 15% infill
53 min
1 plate
Boost
87
182
16
2
270
218
Released
Description
Here is my clean way to organize my cables messed up.
The organizer clips together perfectly.
I stuck it under the table with double-sided tape.
Comment & Rating (16)
All
Print Profile
0.2mm layer, 2 walls, 15% infill
these are great! printed in ASA. my cable management isn’t as pretty but these do a great job and will be easy to swap whenever I need to add other cables
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfekt
0
Reply
This was a decent design. The print failed because of the printer. I also scaled it a bit too big. Good model none the less.
0
Reply
@elikoll Nice design! Could you create a version where the lower part can be attached with screws? The screw should ideally be on the inside, or could you release the STP files?
I would appreciate that!
The designer has replied
1
Reply
yea i will make a other Version i will be able to make it in a week.
1
Reply
Boosted
10/10
0
Reply
Print Profile
A1 mini, 0.2mm layer, 2 walls, 15% infill
mehrfach gedruckt. Ergebnis bestens.
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
perfekt für meine Anwendungen. Danke
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
(Edited)
0
Reply
Print Profile
0.2mm layer, 2 walls, 15% infill
0
Reply
Print Profile
A1 mini, 0.2mm layer, 2 walls, 15% infill
0
Reply
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld