This is a 3D Model for storing up to ten (10) GoPro Batteries (enduro or regular) and two (2) Dual Battery Charging Docks in the rear. Yes my business name is printed on the front. I designed it from scratch and would like credit if anyone does use it for themselves. Please no businesses (including YOUTUBE Channels) without reaching out to me first, my email is below. Any personal use is welcome. Allows for charging while in case with top on or off. Top can also act as a stand for the mics while charging or sitting on the table. If the RAW files are requested, I will clean them up and upload them.

Any comments, good or bad, are appreciated. Should print in under 3 hours and 35 minutes, with the following settings.

Any Color - Printed in PLA (Green Basic)

.28mm Extra Draft @BBL P1P

Quality|

Layer Height - 0.28 mm

Initial Layer Height - 0.2 mm

Seam Position - Back

Only one wall on top surfaces - Not applied

Only one wall on first layer - ‘unchecked’

Strength|

Walls loops - 2

Top surface pattern - Rectilinear

Top shell layers - 4

Top shell thickness - 1.12mm

Bottom surface pattern - Rectilinear

Bottom shell layers - 5

Bottom shell thickness - 2.24mm

Internal solid infill pattern - Rectilinear

Sparse infill density - 15%

Sparse infill pattern - Aligned Rectilinear

Support|

Enable support - ‘unchecked’

Type - n/a

Threshold angle - n/a

On build plate only - ‘unchecked’

Support/raft base - n/a

Support/raft interface - n/a

Others|

Skirt loops - 0

Skirt height - n/a

Brim type - No-brim

Brim width - n/a

Prime Tower - ‘unchecked’

Flush options - n/a

Print sequence - By later