Print Profile(2)
Ver 1. 0.2mm layer, 2 walls, 13% infill
Designer
7.5 h
1 plate
Ver 2. 0.2mm layer, 2 walls, 13% infill
Designer
3.2 h
1 plate
Boost
120
133
13
1
254
41
Released
Description
Hello.
Our new pen holder model.
Inspired by Italy's beautiful architectural and design, tower of Pisa we made these two versions pen holders.
Easy to print, beautiful model and useful at the same time.
In ver. 1 you can fit more pens and still have a compartment for small things
In ver. 2, you only have room for one pen, and a small stand for storing small things.
In the picture below you can see ver. 1 and ver. 2
Enjoy printing :D
Comment & Rating (13)
All
Print Profile
Ver 2. 0.2mm layer, 2 walls, 13% infill
Should have scaled it up just abit but good nevertheless!
The designer has replied
3
Reply
Thank you for sharing it :)
0
Reply
Nice model! 👍👍👍
The designer has replied
1
Reply
Thank you 😀
0
Reply
Print Profile
Ver 1. 0.2mm layer, 2 walls, 13% infill
Sehr schön 👍
The designer has replied
1
Reply
nice :)
0
Reply
Print Profile
Ver 1. 0.2mm layer, 2 walls, 13% infill
Great model!
The designer has replied
1
Reply
nice, thanks for photo :)
(Edited)1
Reply
Print Profile
Ver 1. 0.2mm layer, 2 walls, 13% infill
very successful
1
Reply
Print Profile
Ver 1. 0.2mm layer, 2 walls, 13% infill
The designer has replied
1
Reply
nice :)
0
Reply
Print Profile
Ver 1. 0.2mm layer, 2 walls, 13% infill
1
Reply
Print Profile
Ver 1. 0.2mm layer, 2 walls, 13% infill
1
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-Noncommercial-Share AlikeRelated Models
© 2024 MakerWorld