Dwarf Dice Axe for DND
Copyright Claim
Dwarf Dice Axe for DND
Boost
36
60
10
Print Profile(2)
Entire axe
Designer
5.1 h
1 plate
A1 Mini Version
Designer
5.2 h
2 plates
Boost
36
60
10
5
82
61
Released
Description
This axe should be printed without supports the middle holds dice. There is a part for to screw on at the bottom of the axe. the hole in the axe to hold dice is about 24 mm in diameter. It should hold a standard set of dice. Let me know if you print it. The second picture shows a cut away shot of the tube where the dice go.
Comment & Rating (10)
All
Boosted
Print Profile
A1 Mini Version
just wish the shaft was longer
The designer has replied
0
Reply
How much longer would you want it?
0
Reply
Boosted
Replying to @thatcaddad
probably 6inches
0
Reply
Print Profile
Entire axe
love it came out good would be be better if gyroid infill was used
The designer has replied
0
Reply
Good calll. I need to set my default to gyroid. I usually use it. Do you happen to have a picture of it? I’d love to see it in real life.
0
Reply
gunmetal gray pla
(Edited)
1
Reply
Boosted
Print Profile
Entire axe
great print
0
Reply
Print Profile
A1 Mini Version
0
Reply
Print Profile
Entire axe
0
Reply
Print Profile
Entire axe
0
Reply
No more
License
This work is licensed under a
Creative Commons Attribution-NoncommercialRelated Models
© 2024 MakerWorld