Because I didn't find any, I created one by myself.

Legia Warszawa Herb crest HueForge

Dimensions: 100x126mm

I used my filaments with colors matching the original. Below are only suggestions of filaments.

I used:

• BambuLab Green
• eSun PLA+ White
• eSun PLA+ Black
• eSun PLA+ Red

Print at 100% infill with a layer height of 0.08mm with a base layer of 0.16mm

Filaments Used:
PLA BambuLab Basic Black Transmission Distance: 0.6
PLA BambuLab Basic Red Transmission Distance: 4
PLA BambuLab Basic BambuLab Green Transmission Distance: 2
PLA BambuLab Basic Jade White Transmission Distance: 5

Swap Instructions:
Start with Black
At layer #8 (0.72mm) swap to Red
At layer #12 (1.04mm) swap to BambuLab Green
At layer #13 (1.12mm) swap to Jade White for the rest.